Ventahood

Custom Wall Mount and Island Liners/Blowers for Wood Hoods

Vent-A-Hood Main | Under Cabinet | Wall Mount | Island | Liners/Blowers

Other Custom Liners

All Vent-A-Hood products are suitable for use in damp locations (such as an outdoor covered patio), when installed in a GFCI protected branch circuit.

Note: The only place the liner insert and the shell (wood hood etc.) must touch is at the bottom perimeter of the metal liner insert. The liner can be much shorter than the decorative hood itself. Pre-drilled holes around the bottom, allow the liner to be easily attached to the shell with the included screw kit. In addition, a trim kit is provided to conceal the screw heads, providing a finished appearance.

BHLD/BFLD

BHLD/BFLD

Vent-A-Hood one-piece liners are pre-wired, pre-assembled, ready-to-install and consist of canopy, blower, lighting and switches. All missing dimensions must be specified.

There are no Technical Specification Sheets for Custom Liners. Please contact your Vent-A-Hood dealer.

Model Number Breakdown
Ex: BH200LD-B SS

What makes Vent-A-Hood so special?

B
Wall Mount liner.
H
Halogen lighting.
F = fluorescent lighting.
200*
Dual, 300/600 CFM blower.
LD
Custom liner model.
-
B
Width range:
A = 24" - 36" for 300 or 600 CFM.
B = 36+" - 48" for 600 CFM.
C = 48+" - 54" for 600 CFM.
D = 42" - 54" for 900 CFM.
E = 48" - 66" for 1200 CFM.
SS**
Liner finish.
SS = St. Steel.

Other model number examples might be: BH200LD-C BL or BF400LD-E WH, where BL = black and WH = white.

A "1"* A "100" here indicates a 300 CFM, single blower (450 equivalent CFM).

A "2"* A "200" here indicates a 300/600 CFM, dual blower (900 equivalent CFM).

A "3"* A "300" here indicates one 300 CFM single blower and one 300/600 CFM dual blower (900 CFM total = 1350 equivalent CFM).

A "4"* A "400" here indicates two 300/600 CFM dual blowers (1200 CFM total = 1800 equivalent CFM).

What does Equivalent CFM mean?

CFM ratings, for hoods using mesh or baffle filters, are overstated by approximately 1/3 because they are tested without the filters in place. A mesh or baffle filtered hood, rated at 450 CFM, actually delivers only about 300 CFM of airflow after the filters are placed in the air stream.

Because it uses a centrifugal filtration system with nothing to obstruct the airflow, the Vent-A-Hood Magic Lung® blower is much more efficient, delivering airflow equivalent to a "filtered" hood - but with a lower CFM rating. When comparing the Magic Lung® to blower units made by other manufacturers, use the "Equivalent CFM".

** In addition to stainless steel, Vent-A-Hood is also available in standard painted finishes plus dozens of custom paint colors. Copper and brass overlay are not available for this model. Click here to view the available custom paint colors: www.tigerdrylac.com/fileadmin/usa/Template/pdf/ralcolorchart.pdf.